Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:evo:engmech07a [2019/11/06 23:51] – [Making 91-03 Breather Bolt Holes Smaller] hippysmack | techtalk:evo:engmech07a [2019/11/07 00:06] (current) – [Making 91-03 Breather Bolt Holes Smaller] hippysmack | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| {{: | {{: | ||
| - | The internal hole on the outside | + | The internal hole on the outside end of 91-03 breather bolts is factory tapped 5/ |
| It's not known at this time why as the thread are not used on OEM Sportsters. \\ | It's not known at this time why as the thread are not used on OEM Sportsters. \\ | ||
| - | Below and for lack of having fine thread 5/16" bolts, course thread SS (5/ | + | Below and for lack of having fine thread 5/16" bolts, course thread SS (5/ |
| But it's easier to go and buy the correct bolts. \\ | But it's easier to go and buy the correct bolts. \\ | ||
| The holding block was needed to keep the bolt straight while boring a hole through it. \\ | The holding block was needed to keep the bolt straight while boring a hole through it. \\ | ||
| - | You could use a block of wood, plastic or steel. The hole was .2720" and tapped 5/ | + | You could use a block of wood, plastic or steel. The hole was drilled |
| Each bolt was screwed into the hole, corner to corner lines drawn across the head to find center and the center punched to keep the bit from wandering. \\ | Each bolt was screwed into the hole, corner to corner lines drawn across the head to find center and the center punched to keep the bit from wandering. \\ | ||
| Line 26: | Line 26: | ||
| Normally, marking center on both ends and sending the drill bit in just over half way from each end will make a more straight thru hole. \\ | Normally, marking center on both ends and sending the drill bit in just over half way from each end will make a more straight thru hole. \\ | ||
| But this just being a test, the hole was drilled thru from one side. \\ | But this just being a test, the hole was drilled thru from one side. \\ | ||
| + | The hole ended up off center in the thru end but this is not a critical point in this application. \\ | ||
| {{: | {{: | ||
