Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:ih:engctl01c [2021/06/24 01:03] – [Prestolite Electronic Ignition System] hippysmack | techtalk:ih:engctl01c [2025/07/28 22:59] (current) – [Prestolite Electronic Ignition System] hippysmack | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== IH: Engine Control - Sub-01C ====== | ====== IH: Engine Control - Sub-01C ====== | ||
| ====== Prestolite Electronic Ignition System ====== | ====== Prestolite Electronic Ignition System ====== | ||
| - | |||
| **(1979)** Upgrade to the breaker point system in which the mechanical points are replaced by a breaker-less electronic ignition on the camshaft. Timer has a rotor with one small lobe and one large lobe and a sensor that sends signal to the control module on the back of the timer inner cover. Rotor is mounted on a mechanical flywheel centrifugal advance like a point cam would be in a breaker point system. The rotor' | **(1979)** Upgrade to the breaker point system in which the mechanical points are replaced by a breaker-less electronic ignition on the camshaft. Timer has a rotor with one small lobe and one large lobe and a sensor that sends signal to the control module on the back of the timer inner cover. Rotor is mounted on a mechanical flywheel centrifugal advance like a point cam would be in a breaker point system. The rotor' | ||
| - | |{{: | + | {{: |
| * **In November of 1978**, the MoCo issued a few recommendations to dealers to handle issues with the leaned out condition related to this new ignition system. Motorcycles operate with leaner air/fuel mixtures and are more sensitive to carburetor mixture settings / ignition spark. ((HD Service Bulletin #M-739 dated November 3, 1978)) | * **In November of 1978**, the MoCo issued a few recommendations to dealers to handle issues with the leaned out condition related to this new ignition system. Motorcycles operate with leaner air/fuel mixtures and are more sensitive to carburetor mixture settings / ignition spark. ((HD Service Bulletin #M-739 dated November 3, 1978)) | ||
| Line 20: | Line 19: | ||
| * Make a new timing mark with a piece of chalk at the extreme rear edge of the timing hole. | * Make a new timing mark with a piece of chalk at the extreme rear edge of the timing hole. | ||
| * Start the engine and set the idle speed at 2000 rpm. Retard the timing by shifting the timer plate so the new timing mark moves toward the front of the timing inspection hole. The timing advance should only be reduced in 2-1/2° increments and only enough to correct the problem. Timing should not be changed more than 10° (when the new timing mark is at the extreme front edge of the timing inspection hole). | * Start the engine and set the idle speed at 2000 rpm. Retard the timing by shifting the timer plate so the new timing mark moves toward the front of the timing inspection hole. The timing advance should only be reduced in 2-1/2° increments and only enough to correct the problem. Timing should not be changed more than 10° (when the new timing mark is at the extreme front edge of the timing inspection hole). | ||
| - | |||
| + | ===== Nosecone Ignition Seal ===== | ||
| + | This is a steel shell radial shaft seal (HD# 11124) installed in the cam cover. \\ | ||
| + | It surrounds and seals #2 cam when the cover is installed. Also used on 1986-2003 model Sportster cam covers. \\ | ||
| + | Dims per XLForum member, Fizzle: \\ | ||
| + | OD 1.570" (39.878mm) | ||
| + | ID 1.050" (26.67mm) | ||
| + | W 0.248" (6.2992mm) | ||
| + | |||
| + | Other brands include James (JGI-11124), | ||
| + | The rubber shell HD Genuine double lip version is part number (11124-DL). \\ | ||
| + | Other brands include James (JGI-11124-DL). \\ | ||
| + | **NOTE**: __SKF makes a radial shaft seal with a part number of 11124 but that IS NOT AN HD PART NUMBER__. \\ | ||
| + | SKF 11124 IS TOO BIG TO FIT THE COVER and they don't show a compatible seal in their catalog for this application. \\ | ||
| + | |||
| + | HD Seal (11124): \\ | ||
| + | |||
| + | {{: | ||
| \\ | \\ | ||
