Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:ref:carb05 [2018/12/18 17:23] – hippysmack | techtalk:ref:carb05 [2024/01/11 22:54] (current) – hippysmack | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== REF: Carburetor, Intake Manifold & Exhaust ====== | ====== REF: Carburetor, Intake Manifold & Exhaust ====== | ||
| ====== Fuel Lines and Modifications ====== | ====== Fuel Lines and Modifications ====== | ||
| + | |||
| + | ====== Copper Fuel Lines ====== | ||
| + | |||
| + | | Copper oil and gas lines ((photos by calabeast of the XLFORUM https:// | ||
| + | |{{: | ||
| + | |||
| ====== Custom Bends Using Copper Tubing ====== | ====== Custom Bends Using Copper Tubing ====== | ||
| When changing to a different petcock or fuel tank, sometimes the lines are difficult to route and still keep the kinks out. \\ | When changing to a different petcock or fuel tank, sometimes the lines are difficult to route and still keep the kinks out. \\ | ||
| Line 9: | Line 15: | ||
| This was done using 1/4" copper tubing. \\ | This was done using 1/4" copper tubing. \\ | ||
| - | * Simply cut a few short pieces of copper. ((photos by Jtrapass of the XLFORUM | + | * Simply cut a few short pieces of copper. ((photos by Jtrapass of the XLFORUM |
| * Make the initial lengths too long so the bender has plenty of tubing to bite on for making the radius. | * Make the initial lengths too long so the bender has plenty of tubing to bite on for making the radius. | ||
| * Then use a tubing bender to make the bends you need. | * Then use a tubing bender to make the bends you need. | ||
| Line 20: | Line 26: | ||
| - | |{{:techtalk: | + | |{{techtalk: |
| * After inserting the bends in the hose, cut the ends to length and install as usual. | * After inserting the bends in the hose, cut the ends to length and install as usual. | ||
| - | |{{:techtalk: | + | |{{techtalk: |
