Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| techtalk:ref:carb05 [2019/01/09 04:15] – ↷ Links adapted because of a move operation ixl2relax | techtalk:ref:carb05 [2024/01/11 22:54] (current) – hippysmack | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ====== Copper Fuel Lines ====== | ====== Copper Fuel Lines ====== | ||
| - | | Copper oil and gas lines ((photos by calabeast of the XLFORUM | + | | Copper oil and gas lines ((photos by calabeast of the XLFORUM |
| |{{: | |{{: | ||
| + | |||
| ====== Custom Bends Using Copper Tubing ====== | ====== Custom Bends Using Copper Tubing ====== | ||
| When changing to a different petcock or fuel tank, sometimes the lines are difficult to route and still keep the kinks out. \\ | When changing to a different petcock or fuel tank, sometimes the lines are difficult to route and still keep the kinks out. \\ | ||
| Line 14: | Line 15: | ||
| This was done using 1/4" copper tubing. \\ | This was done using 1/4" copper tubing. \\ | ||
| - | * Simply cut a few short pieces of copper. ((photos by Jtrapass of the XLFORUM | + | * Simply cut a few short pieces of copper. ((photos by Jtrapass of the XLFORUM |
| * Make the initial lengths too long so the bender has plenty of tubing to bite on for making the radius. | * Make the initial lengths too long so the bender has plenty of tubing to bite on for making the radius. | ||
| * Then use a tubing bender to make the bends you need. | * Then use a tubing bender to make the bends you need. | ||
