Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:engmech03k [2019/07/21 00:48] – [Chopping OEM Sprocket Cover Into a Gothic Cross] hippysmack
+++ techtalk:ref:engmech03k [2019/07/21 01:02] (current) – [Chopping OEM Sprocket Cover Into a Gothic Cross] hippysmack
@@ Line 12: / Line 12: @@
 \\
+Total of about 48 hours. \\
 Measurements taken with the graphic idea rough sketched. \\
@@ Line 35: / Line 36: @@
 {{:techtalk:ref:engmech:sprocket_cover_mod_13_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_14_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_15_by_anachris.jpg?direct&200|}} \\
-Total of about 48 hours. \\
 The VHT wrinkle plus went on gloss (very gloss) with at least 3 coats at varying angles and given a couple of hours for the paint to set. \\
 Then it was heated in the oven at 200 degrees. \\
@@ Line 52: / Line 52: @@
 {{:techtalk:ref:engmech:sprocket_cover_mod_22_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_23_by_anachris.jpg?direct&300|}} {{:techtalk:ref:engmech:sprocket_cover_mod_24_by_anachris.jpg?direct&300|}} \\
-A brass woven mesh sheet was cut as a backing the sprocket cover. \\
+A brass woven mesh sheet was cut as a backing for the sprocket cover. \\
 (unpolished, mill finish, ASTM E2016-06, 12" width, 12" length, 0.025" wire diameter, 54% open area) \\
+{{:techtalk:ref:engmech:sprocket_cover_mod_21_by_anachris.jpg?direct&200|}} \\
 Finished product: \\
-{{:techtalk:ref:engmech:sprocket_cover_mod_21_by_anachris.jpg?direct&200|}} {{:techtalk:ref:engmech:sprocket_cover_mod_25_by_anachris.jpg?direct&300|}} \\
+{{:techtalk:ref:engmech:sprocket_cover_mod_25_by_anachris.jpg?direct&300|}} \\

Trace: • EVO: Engine Mechanicals - Sub-09E • EVO: Suspension - Sub-01C • EVO: Engine Mechanicals - Sub-04E • REF: Engine Mechanicals - Sub-03K

Differences

Navigation

Search

Toolbox