This is an old revision of the document!
REF: Engine Mechanicals - Sub-03K
See also:
Chopping OEM Sprocket Cover Into a Gothic Cross
Article by anachris of the XLFORUM 1)
Measurements taken with the graphic idea rough sketched.
Two basic patterns of the cross were selected and mocked up.
After settling on the pattern, it's just a matter of gluing on a paper pattern over the cover and cutting it out.
With the basic shape rough cut, a drill press with spiral cutter was used to clean up the mess of all the drill holes.
The wrinkle black will be grinded, sanded and repainted wrinkle black as the rest of the engine with the nut painted red.
The rough shaping was done with files and test fitted once again.
Finish shaping and sanded with sandpaper and getting ready for the wrinkle paint.
