Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| techtalk:ref:svcproc11b [2021/08/24 01:59] – hippysmack | techtalk:ref:svcproc11b [2024/01/21 06:06] (current) – hippysmack | ||
|---|---|---|---|
| Line 85: | Line 85: | ||
| The washer is flat edged on one side and has a rounded edge on the other resulting a " | The washer is flat edged on one side and has a rounded edge on the other resulting a " | ||
| The pawl end play near the bottom hook in the pic below was measured at .043" (3.6322mm). \\ | The pawl end play near the bottom hook in the pic below was measured at .043" (3.6322mm). \\ | ||
| - | XLForum member, xLoneRiderx, | + | XLForum member, xLoneRiderx, |
| End play will be variable due to wear and probably quality control on the parts themselves as well as the point that is measured. \\ | End play will be variable due to wear and probably quality control on the parts themselves as well as the point that is measured. \\ | ||
| The pawl is responsible for lifting or lower the pins on the shift drum (which cause the drum to turn). \\ | The pawl is responsible for lifting or lower the pins on the shift drum (which cause the drum to turn). \\ | ||
| Line 92: | Line 92: | ||
| If the pawl is forced to lean outward at the same time, the shaft is also forced from that direction as well. \\ | If the pawl is forced to lean outward at the same time, the shaft is also forced from that direction as well. \\ | ||
| - | | Shift Pawl Connection to the shift arm ((photos by xLoneRiderx of the XLFORUM | + | | Shift Pawl Connection to the shift arm ((photos by xLoneRiderx of the XLFORUM |
| |{{: | |{{: | ||
